Customer Helpline
0333 3201989
13
Operating Instructions
11. Battery Capacity Indication
Your tool is equipped with Battery Capacity Indication (11). Press the On/Off Switch (9)
halfway or fully, the Battery Capacity Indication (11) will light up to show the amount of
charge left in the battery.
Fuel Gauge
Capacity
3 lights
>
70%
2 lights
>
40%
1 light
<
40%
1 flashing light
Recharge battery
12. BELT CLIP (SEE FIG F)
Screw the Belt Clip (7) on the tool with the screw provided in the plastic bag. The belt
clip (7) can be cliped on your belt or pocket, etc.
13. DRILLING
To activate the drill function (For drilling metal wood or plastic), turn the torque
adjustment ring on the drill position.
HINTS
:
When drilling in metal, only use HSS drill bits in good condition. Always use a
magnetic bit holder (not included) when using short screwdriver bits. When screw-
driving, apply a small quantity of liquid soap or similar to the screw threads to ease
insertion. For metal surfaces use a centre punch to mark the desired hole.
14. OVERLOAD PROTECTION
When overloaded, the motor comes to a stop. Relieve the load on the tool immediately
and release the on/off switch. Restart the tool as normal.
15. TEMPERATURE DEPENDENT OVERLOAD PROTECTION
When using as intended for the power tool cannot be subject to overload. When the
load is too high or the allowable battery temperature is too hot, the electronic control
switches off the power tool until the temperature is in the optimum temperature range
again.
16. PROTECTION AGAINST DEEP DISCHARGING
The LITHIUM-ION battery is protected against deep discharging by the “Discharging
Protection System”. When the battery is empty, the tool is switched off by means of a
protective circuit: The drill will no longer rotate. Remove the battery and recharge.