Customer Helpline 0333 3201989
12
Operating Instructions
If you want to activate the drill function (For drilling metal wood or plastic), turn the
torque adjustment ring on the drill position.
Tungsten carbide drill bits should always be used for concrete and masonry.
When drilling in metal, only use HSS drill bits in good condition. Always use a
magnetic bit holder (not included) when using short screwdriver bits. When screw-
driving, apply a small quantity of liquid soap or similar to the screw threads to ease
insertion.
11. DISPOSAL OF AN EXHAUSTED BATTERY PACK
To preserve natural resources, please recycle or dispose of the battery pack properly.
This battery pack contains Lithium batteries. Consult your local waste authority for
information regarding available recycling and/or disposal options. Discharge your
battery pack by operating your drill, then remove the battery pack from the drill housing
and cover the battery pack connections with heavy-duty adhesive tape to prevent short
circuit and energy discharge. Do not attempt to open or remove any of the components.
12. OVERLOAD PROTECTION
When overloaded, the motor comes to a stop. Relieve the load on the tool immediately
and release the on/off switch. Restart the tool as normal.
13. TEMPERATURE DEPENDENT OVERLOAD PROTECTION
When using as intended for the power tool cannot be subject to overload. When the
load is too high or the allowable battery temperature is too hot, the electronic control
switches off the power tool until the temperature is in the optimum temperature
range again.
14. PROTECTION AGAINST DEEP DISCHARGING
The LITHIUM-ION battery is protected against deep discharging by the “Discharging
Protection System”. When the battery is empty, the tool is switched off by means of a
protective circuit: The drill will no longer rotate. Remove the battery and recharge.
F
