Customer Helpline 0333 3201989
9
NOTE: Before using the tool, read the instruction book carefully.
Intended Use
This tool is intended for driving in and loosening screws as well as for drilling in wood,
metal and plastic.
1. CHARGING PROCEDURE
BEFORE PUTTING INTO OPERATION
CHARGING THE TOOL OR BATTERY PACK (SEE FIG A)
NOTE:
a) Do not use any charger other than that specifically provided for use with the
equipment.
b) If the battery pack is very hot you must remove your battery pack from the charger
and allow time for the battery to cool down before recharging.
c) The battery in your new tool is not charged when it leaves the plant. Therefore it
must be full charged before using the first time
d) Please charge the battery to reach full or no less than half charge before storage. If
the tool will not be used for long periods of time, charge the battery every 3-6 months
CHARGING PROCEDURE
Plug charger plug into a suitable power outlet and afterwards plug the DC plug into
socket of your battery pack, the charging indicator (red) will illuminate at this time.
The charger indicator (red) will go out and the charging indicator (green) will illuminate
when charging is complete, then unplug the charging plug from the wall socket and then
remove the battery charger from the battery, the battery is ready to use.
Important:
When charging, the charger and battery may become warm to the touch, this is normal
and does not indicate a problem.
WARNING: When battery charge runs out after continuous use or exposure to
direct sunlight or heat, allow time for the tool to cool down before re-charging
to achieve the full charge.
Operating Instructions
A
