Customer Helpline 0333 3201989
11
Operating Instructions
the front chuck section in the opposite directions. Your drill bit is now clamped in the
chuck.
7. TORQUE ADJUSTMENT (SEE FIG. E)
(Screw driving force of your drill driver)
The torque is adjusted by rotating the torque adjustment ring. The torque is greater
when the torque adjustment ring is set on a higher setting. The torque is less when the
torque adjustment ring is set on a lower setting.
When drilling in wood, metal, plastic and screwdriver choose the drill position
Make the setting as follows:
1 - 4
for driving small screws
5 - 9
for driving screws into soft material
10 - 12
for driving screws into soft and hard material
13 - 15
for driving screws into hard wood
16
for driving larger screws
for heavy drilling
8. USING THE SIGHT LIGHT
To turn on the light simply press the on/off switch and make sure the forward/reverse
rotation control is on right/left position. When you release the on/off switch, the light will
be off.
LED lighting increases visibility-great for dark or enclosed area.
9. BELT CLIP (SEE FIG F)
Screw the Belt Clip (7) on the tool with the screw provided in the plastic bag. The belt
clip (7) can be cliped on your belt or pocket, etc.
10. DRILLING
When drilling into a hard smooth surface, use a center punch to mark the desired hole
location. This will prevent the drill bit from slipping off center as the hole is started. Hold
the tool firmly and place the tip of the bit at the point to be drilled. Depress the switch
trigger to start the tool. Move the drill bit into the workpiece, applying only enough
pressure to keep the bit cutting. Do not force or apply side pressure to elongate a hole.
D
E
