6. Install the extension arms
1 2 3 4
Loosen the screw [1], take out the baffle plate [2], and insert the extension arm into the yaw axis. Secure it with
4 M4*20 screws [3]. Tighten it with 1 M3*10 head screw [4]. You are now finished installing the yaw-axis
extension arm.
1 2 3
Take out 4 screws at [1], dismantle the rolling arm, and take out the roll-axis extension arm [1]. Fit the roll-axis
extension arm to the parting position and use 7 screws to fix the port [3] to finish the installation.
7.Installing the Upper Mounting Kit
2 3
1
Loosen the tilt arm by loosening the knob at [1]. Insert the upper tilt arm to the connector [2] and tighten the
knob.
Loosen the knob at [3], and adjust the locking kit until its screw hole fits into the camera. Then, tighten the
camera with either the
¼”
or 3/8
”
screw.