Fig. 4
First, determine the cutting angle of sharpening
the teeth inner surfaces. The surfaces should be
parallel to the flat area of the grinding. Se arrow in
Fig.4 and Fig. 5)
Fig. 5
Sharpening is done by sliding the slide forward
and backward. M ind the slide set up to provide for
the hard metal surface to be sharpened The
oblong hole in the slide works as a stop. (see Fig.
6)
Fig. 6
Here, it is clear that the feed slide is set in parallel
to the grinding wheel and the slide goes to the
stop, the grinding wheel works the hard metal
surface only. Also, the set up to work smaller
grinding wheel.
Caution:
Be very careful to move the saw disc on the slide in order to prevent any damage of the
diamond disc!
a
23
