6
Operation
Fig. 1
Basically it is possible to sharpen saw discs of
diameter
80 mm - 700 mm.
Fix the disc on the feed slide. The feed slide has
three centring holes. According to the centring
hole, it is possible to mount various diameters of
saw discs.
Fig. 2
First, select a centring hole and loosen up the
clamping screw (Fig. 1b), now, the feed slide may
turn by 360°. With small diameters of the saw disc
it is recommended to use a centring hole (Fig. 2a),
on medium diameters, one of two additional holes.
Using a hand wheel, it is possible, upper slide
may be adjusted. First loosen clamping screw out
(Fig. 1c). The diameter of the disc to be worked
may be set up after it is loosened up.
Fig. 3
When you find an appropriate distance between
the centring hole and the grinding wheel, fix the
upper slide with clamping screw (Fig. 1c), Now,
the disc may be placed in the middle of centring
hole. Now, put a suitable adapter in the saw disc
Put clamping disc (Fig. 3a) above the adapter and
fix it with a screw.
TIP: Tighten the clamping screw so that the saw
disc may bet turned without taking too much
power.
c
a
b
a
a
22
