Expert
Power
Control NET
8x
10
11
Expert
Power
Control NET
8x
Configuration - HTTP
HTTP Port
Here you can enter hte HTTP
port number, if necessary.
Possible numbers are 1 ...
65534 (standard: 80). To get
access to EPC NET 8x, you
have to enter the port number
behind the IP address of
EPC
NET 8x
:
http://192.168.0.2:1720
Require HTTP Password
Password protected access
can be activated here. In this
case, a user and an admin password have to be defined. Pass-
words have a maximum lengths of 15 characters.
Administrators are authorized to switch all ports and to modify
the settings of
EPC NET 8x
and of all ports. The username of
the admin is
“admin”
.
Users are authorized to switch all ports but are not allowed to
modify the settings of neither
EPC NET 8x
nor the ports. The
username of the user is
“user”
.
If you have forgotten your password, activate the bootloader
mode of EPC NET 8x, start GBL-Conf.exe and deactivate the
password request.
All changes need a restart of the firmware to get valid.
Configuration - Messages
Here you can configure if and
at which Min-/Max-Tempera-
ture EPC NET 8x shell send
temperature alerts via SNMP-
Traps and Syslog.
Figure 8 Configuration - HTTP
Figure 9: Configuration - Messages
