GÜDE Expert Sensor Box 7213, Manual

Page: 14 / 100

14
Expert Sensor Box 7213/7214 © 2022 GUDE Systems GmbH
Operating
2 Operating
2.1 Operating the device directly
Status-LED
The Status LED shows the different states of the device:
·
red: The device is not connected to the Ethernet.
·
orange: The device is connected to the Ethernet and waits for data from the DHCP
server.
·
green: The device is connected to the Ethernet and the TCP/IP settings are allocated.
·
periodic blinking: The device is in Bootloader mode.
Switching the relay with the button (only ESB 7214)
Press and hold the button for a total of 6 seconds. After the first 3 seconds the status
LED flashes in a long ON, short OFF rhythm. Wait another 3 seconds, and the status
LED flashes in a twice short, and once long rhythm. At this moment, press the button
once again briefly to switch the relay, or if you wait 6 seconds instead, the device re-
turns to its initial state.
2.2 Control Panel
The relay output, the passive signal input and the additional input for the power sup-
ply are only available on the Expert Sensorbox 7214. The possibility of power supply via
Power-over-Ethernet (PoE) also varies depending on the model.
Access the web interface: http://"IP-address" and log-in.
The web page provides an overview of the switching state, the sensor, as well as the ex-
ternal sensors, provided that they are connected. When the port is clicked, a panel with
buttons to control the port appears: