27
10.63 Gate Lock State
If you connect a gate lock to the system, you need to enable this function, and set
UNLOCK TIME
for it, also
you need to set UNLOCK SIGNAL TYPE(NORMAL OPEN or NORMAL CLOSE) according to gate lock type.
10.64 Exit Button Control Type
Set exit button control target, it can be gate or door according to the actual installation. Press the exit button
can open the door/gate.
10.65 Associated Unlocking Device
The associated unlocking device information will only display after the unlock devices are connected into the
system.
10.7 Elevator control state
It can disable/enable elevator control function.
10.8 Set Doorbell Security Parameters
10.81 Tamper State
The tamper in the door station will be active after enable this function, and it will alarm when someone tries to
disassemble the door station. Also you need to set TARGET ROOM NUMBER FOR HANDLING ALARMS.
10.82 Check Door State
If enable this function, the system will check the door state after longest door open time. Set MAGNETIC
CONTACT NODE TYPE to NORMAL OPEN or NORMAL CLOSE according to actual needs. Set LONGEST
DOOR OPEN TIME. Once the door is open, the door station will detect the door state after it reaches longest
door open time. If the door is not closed after the longest door open time, the door station will alarm with
beeps sound.
10.9 Set the Doorbell Speaker Volume
You can set 10% to 100% volume according to actual needs.
11.0 Adjust the Viewing Angle
You can adjust the viewing angle for the door station. Touch ADJUST THE VIEWING ANGLE to start
monitoring. Touch the place you want to focus on the screen. Then touch hang up icon
to exit the
monitoring. Finally, touch the return icon on the top left corner or slide left on the screen, touch CONFIRM to
finish the setting. After that, the screen will be only showing the focused place when be called by the door
station.
11.1 Set the Doorbell Configuration Password
The password can be maximum 8 digits. You only need to input from the first digit which is not 0.
11.2 Setup Mode
It
’s on by default. At this state, the addresses of the monitors in the network can be set freely. If disable it, the
