GUARDEON Security Systems ApS. Vandtårnsvej 100, 2860 Søborg CVR: 37769568 T: +45 72 17 00 28 W: guardeon.dk E: [email protected]
4
ANTI-REMOVAL TAMPER (INCLINOMETER)
The sensor is provided with an anti-removal function (that can be activated with
DIP1
) which
establishes whether the sensor is moved from the installing position.
This function is activated just when the sensor is in the HORIZONTAL position and afterwards
it is inclined. In order to activate the removal detection, it is necessary to put the sensor
horizontally: from now on the anti-removal is activated; if the sensor moves it indicates tamper
alarm.
POWER-ON
BEFORE POWER THE SENSOR
If the sensor is already powered (or at battery change), before proceed it is necessary to
disconnect the battery, open the jumper
J.TMP
and hold the tamper switch for about 10
seconds: in this way the circuit will be completely discharged and will be possible to start-up the
sensor correctly.
G-OP-WPIR-W and U
Power the sensor only after all the wiring is completed.
When the sensor is powered, the LEDs light on is sequence for some seconds: the sensore starts
the “
Stabilisation period”
The
Stabilisation period
takes about
2 minutes
(the infrared and microwave LEDa light on
in case of detection)
At the end of the stabilization time, the sensor is ready for use.
BATTERY
(ONLY G-OP-WPIR-U
)
Caution, the device works by lithium battery.
Replace the battery exclusively with one of the same type.
Follow the polarity indicated in the instructions.
Dispose of empty batteries following the current regulations, even in case of equipment
disposal.
In case of leakage, protect your hands with special gloves.
LOW BATTERY
When the battery is low, the sensor the activates the “low battery” output (model -Universal).
The low battery alert low battery output is activated after three alarm or
supervision transmissions (if in test, it is sent after each transmission).
Depending on the control panel or receiver model, the alert is visualized on display or LED.
Note: the low battery alerts will continue until the battery is replaced.
BATTERY REPLACEMENT
When the battery must be replaced:
Disconnect the old battery
Open the jumper
J.TMP
, then press and hold the tamper switch for at least 3 seconds
(circuit discharge)
Connect the new battery (see the par. “Power on”)
Output Cable
(connect to the transmitter)
Transmitter Space
(maximum dimension)
2
3
I
L
Battery
Sensor board
Transmitter
Connector
(connect to
CN.OUT
)
Low Battery
(yellow wires)
Tamper
(white wires)
Alarm
(red wires)
4
