Operating Instructions
7
3. Safety
The ProSens was designed, built and tested for safety and is shipped in this condition. Components within the
supplied system could be hazardous if not unpacked, installed, connected and commissioned by authorised
qualified persons. All operating instructions must be read, and understood, before handling the system. Failure to
do so will cause the warranty to be revoked.
3.1 Normal Use
•
The measuring system must be installed for measuring dust burden only.
Other usage, or modifications, of the measuring system is not permitted.
•
Only original spare parts and accessories of SWR engineering must be used.
3.2 Identification of Hazards
Possible hazards, when using the measuring system, are marked by the following symbols:
Warning!
•
This symbolises a situation where personal safety is at risk if used in an improper manner.
Attention!
•
This symbolises the possible damage to the system, if used in an improper manner.
3.3 Operational Safety
•
The measuring system must be installed by trained and authorised personnel only.
•
In case of maintenance-work on the pipe or on components of the ProSens-sensor, make sure that the
piping is in unpressurized condition.
•
Switch off the power supply for all maintenance, cleaning or inspection works on the sensor or on
components within the ProSens. Follow the notes of the chapter maintenance.
•
Caution, if welding is required on the pipe, remove sensor.
•
The components and electrical connections must be checked for damages regularly. If a damage is
found, it is to be repaired before further operation of the instruments.
3.4 Technical Statement
•
The manufacturer reserves the right to change any technical data, without prior notice. If any queries
arise, SWR engineering will be happy to informer customers of any possible changes made.
ProSens-BA-EN-2015-01-29.indd 7
30.01.15 12:31
