3
Determining the Mounting Position
of the Post Bracket Assembly and the Gate Bracket
Step 5
With the gate in the open position (up to 0º from its closed position) and the operator fully retracted, adjust the
post bracket assembly and gate bracket until the operator is level. While holding the operator level, use C-clamps to
temporarily
keep the post bracket assembly and gate bracket in their respective positions on the fence post and gate.
Step 3
Insert the
3
/
8
" x 2" bolt through
the center hole of the post
brackets and post pivot bracket
as shown. Fasten a
3
/
8
" lock
washer,
3
/
8
" washer and
3
/
8
" nut
on the end of the bolt. DO NOT
overtighten
the nut because the
post pivot bracket will have to be
adjusted later.
Step 4
Attach post bracket assembly and gate bracket to the operator with the clevis pins and bushings. Secure the clevis pins with
hairpin clips.
3/8" x 2" Bolt
3/8" Nut
Post Pivot Bracket
Post Bracket
Post Bracket
3/8" Lock Washer
Post Bracket Assembly
3/8" Washer
NOTE:
The following steps are
intended for
pull-to-open
gate
installations. If you are mounting
your
operator on a
push-to-open gate
(
e.g., a gate on a sloped driveway)
you will need to purchase a
Push
To Open bracket
(
see Accessory
Catalog
). Also, see
Push-to-Open
Installation
beginning on page 3.
1ZSdWa>W\
6OW`^W\1ZW^
>]ab0`OQYSb/aaS[PZg
0caVW\U
@SO`;]c\b
=^S`Ob]`
Clevis Pin
Hairpin Clip
Gate Bracket
Front Mount
Bushing
:SdSZ=^S`Ob]`
4S\QS>]ab
5ObS7\=^S\>]aWbW]\
:3D3:V]`Wh]\bOZQ`]aa[S[PS`
>]ab0`OQYSb/aaS[PZg
5ObS0`OQYSb