rev 06.13.12
vii
IMPORTANT SAFETY INSTRUCTIONS
Secondary Means of Protection Against Entrapment
As specified by Gate Opener Safety Standard, UL 325 (30A.1.1), automatic gate openers shall have an inherent
entrapment sensing system, and shall have
provisions for, or be supplied with,
at least one independent secondary
means to protect against entrapment. The E-Z Gate Opener utilizes
Type A,
an inherent (i.e., built-in) entrapment sensing
system as the
primary
type of entrapment protection. Also, the E-Z Gate Opener has
provisions for
the connection of
Type B2
protection to be used as the
secondary
type of entrapment protection, if desired.
1. For gate openers utilizing a contact sensor (e.g., safety edge sensor– Type B2) in accordance with UL 325 (51.8.4
[i]):
A. One or more contact sensors shall be located at the leading edge, bottom edge, and post edge, both inside and
outside of a vehicular swing gate system.
B. A hard wired contact sensor shall be located and its wiring arranged so that the communication between the
sensor and the gate opener is not subjected to mechanical damage.
C. A wireless contact sensor such as one that transmits radio frequency (RF) signals to the gate opener for
entrapment protection functions shall be located where the transmission of the signals are not obstructed or
impeded by building structures, natural landscaping or similar obstruction. A wireless contact sensor shall
function under the intended end-use conditions.
You may want to consider adding photo beams to your installation. Photo Beams provide a “non contact” means of
entrapment protection. Call 1-800-543-GATE (4283) for more information.
Leading Edge Contact Sensor
on both sides of the gate
(recommended, not included)
Bottom Edge Contact Sensor
on both sides of the gate
(recommended, not included)
Photo Beam
(recommended, not included)
Photo Beam
(recommended, not included)
ENTRAPMENT ALARM (UL 325; 30A.1.1A)
The E-Z Gate Opener is designed to stop and reverse within 2 seconds when the gate comes in contact
with an obstruction. Additionally, these openers are equipped with an
audio entrapment alarm
which
will activate if the unit obstructs
twice
while opening or closing. This alarm will sound for a period of 5
minutes, or until the opener receives an intended signal from a hard wired entry/exit source (e.g. push
button control or keypad) and the gate returns to a fully open or fully closed position. Turning the power
switch on the control box OFF and back ON will also deactivate the alarm. Wireless controls such as
remotes and wireless keypads will not deactivate the alarm.
