rev 06.13.12
17
Adjust Stall Force Setting
The Stall Force
potentiometer controls the amount of force the opener
will apply against an obstruction before it stops and reverses direction
within two seconds.
IMPORTANT:
The Stall Force setting
will need to be adjusted
to
compensate for the weight and size of your gates. For safety reasons,
use the lowest possible setting to operate the gate.
The Stall Force
potentiometer on the control board operates like a
volume control on a radio. Use a small flat blade screwdriver to turn the
arrow in the center of the potentiometer. Adjust the sensitivity from the
MINIMUM position just to the point where the gates operate smoothly
without obstructing from their own weight or wind conditions.
NOTE: You may need to increase the stall force in cold weather due to
increased resistance from gate hinges.
Set Auto-Close Time
The Auto-Close determines how long the gate will remain open
before it automatically closes. The factory setting is OFF. Use a small
flat blade screwdriver to adjust the settings to OFF, or from 3 to 120
seconds.
NOTE: Auto-Close timer is disabled (gate will not automatically close)
if gate is not at the fully open position.
Re-attach the cover of the control box at this time.
VAR5
VAR6
K1
PF1
K2
BATT
+
BATT
–
K3
K4
VAR4
VAR3
VAR2
VAR1
MIN
MAX OFF
JP1
REMOVE JUMPER FOR
PUSH TO OPEN OPTION
120
SEC.
G
TO Inc.
Tallahassee, FL
R4722
STALL FORCE
OPEN < JOG > CLOSE
PWR.
SET
LIMIT
1st OPR.
2nd OPR.
STATUS
AUTO CLOSE
SFTY.
EXIT
CYCLE
EDGE
SENSOR
COMMON
LOCK+
LOCK–
WHT
GRN
RED
BLK
WHT
GRN
SECOND OPR
.
FIRST OPR
.
RED
BLK
14 VAC
OR
SOLAR
ON OFF
MIN
MAX
STALL FORCE
VAR5
VAR6
K1
PF1
K2
BATT
+
BATT
–
K3
K4
VAR4
VAR3
VAR2
VAR1
MIN
MAX OFF
JP1
REMOVE JUMPER FOR
PUSH TO OPEN OPTION
120
SEC.
G
TO Inc.
Tallahassee, FL
R4722
STALL FORCE
OPEN < JOG > CLOSE
PWR.
SET
LIMIT
1st OPR.
2nd OPR.
STATUS
AUTO CLOSE
SFTY.
EXIT
CYCLE
EDGE
SENSOR
COMMON
LOCK+
LOCK–
WHT
GRN
RED
BLK
WHT
GRN
SECOND OPR
.
FIRST OPR
.
RED
BLK
14 VAC
OR
SOLAR
ON OFF
OFF
120
SEC.
AUTO CLOSE
Control Box Cover
Step 6
Press the remote again to allow the
gates to fully close to verify that the
closed position is set correctly.
Repeat steps 2 - 5 if necessary
.
Control
Box
Gates in Closed
Position
1st
Gate
Opener
2nd
Gate
Opener
