21
5.3 Operating Instructions
5.3.1 UPS ON/OFF Operation
Note
：
The battery is fully charged before delivery. However, storage and
transportation will inevitably cause some charge loss. Therefore, it
is advisable to charge the battery for 10 hours before using it, so as
to ensure adequate battery capacity.
1. Turning on the UPS
The operation of turning on the UPS contains: turning on with utility power
and turning on without utility power.
1) Turning on with utility power:
Connect the mains input to the UPS, press the ON button more than one
second, UPS starts to turn on. At this point, the LCD begins to conduct
self-diagnosis (all the LCD indicators are turn on about 4 seconds). A
few seconds later, the UPS will begin to operate in Normal mode;
meanwhile, the utility power indicator, inverter indicators will turn on. If
the utility power is abnormal, the UPS will work in battery mode.
2) Turning on without utility power:
With no mains input feed to the UPS, press the ON button more than one
second, ups start to turn on, At this point, the LCD begins to conduct
self-diagnosis (all the LCD indicators are turn on about 4 seconds). A
few seconds later, the battery indicator, inverter indicators will be turn on
to indicate that the UPS is working in battery mode.
3). Powering down the UPS
The operation of powering down the UPS contains: turning off ups in
normal mode, turning off ups in battery mode
4) Completely power down the UPS from Normal mode
Hold and press the OFF button persistently for more than 1 second to
22
power off the UPS. If it bas been set up to work in bypass mode by
software, the bypass indicator will be turned on to indicate that the UPS
is working in bypass mode. In order to cut off the output from the UPS,
simply cut off the utility power supply. LCD begins to conduct
self-diagnosis (all the LCD indicators are turned on about 4 seconds),a
few seconds later, not any display is shown on the front panel and no
output is available from the UPS outlets, system completely power down.
5) Completely power down the UPS from Battery mode
Press the “OFF” button persistently for more than 1 second to power off
the UPS. When being powered off, the LCD will start self-diagnosis (all
the LCD indicators are turn on about 4 seconds), a few seconds later, not
any display is shown on the front panel and no voltage output is available
from the UPS outlets, system completely power down.
5.3.2 Conducting Battery self-diagnosis
In UPS operation, users can manually initiate battery self-diagnosis to
check the battery conditions. There are two methods to initiate the battery
self-diagnosis:
1. Through the function button
In normal mode, press and hold the function for more than 2 seconds
until the buzzer beeps twice. At this point the indicators (LED7~10) will
blink cyclically, indicating the UPS has worked in battery mode and the
battery self-diagnosis has started. The battery self-diagnosis will last for
10 seconds default. In the event of a battery fault during battery
self-diagnosis, the UPS will transfer to normal mode automatically.
2. Through the monitor software
Users can also initiate battery self-diagnosis through the background
monitoring software.
