- 2 -
Radio Frequency Energy Notice
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Q
Reorient or relocate the receiving antenna.
Q
Increase the separation between the equipment and receiver.
Q
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Q
Reorient or coil cables.
Q
If necessary, consult the dealer or an experienced radio/television technician for additional suggestions.
Important:
Any cables the user adds to the device must be shielded to be in compliance with the FCC stan-
dards. Any unauthorized modification to this device could result in the revocation of the end user’s authority to
operate this device.
Cordless pen or cursor
This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) This device must accept any interference received, including
interference that may cause undesired operation.
Canada
This digital apparatus does not exceed the Class B limits for radio noise emissions from digital apparatus as set
out in the radio interference regulations of the Canadian Department of Communications.
Le present appareil numerique n’emet pas bruits radioelectriques depassant les limites applicables aux appareils
numeriques de Classe B prescrites dans le reglement sur le brouillage radioelectrique edicte par le Ministere des
Communications du Canada.
Japan
CE Certification
Declaration of conformity according to ISO/IEC Guide 22 and EN 45014
Manufacturer’s Name:
GTCO CalComp, Inc.
Manufacturer’s Address:
14555 N. 82nd Street
Scottsdale, Arizona 85260
U.S.A.
declares, that the product
Product Name:
DrawingBoard III
Model Numbers:
34120, 34180, 34240, 34360, 34480, 34600, 34365, 34485, 34605
Product Options:
All
