- 31 -
SMCIP 401 ASI
i
nPut
symbol
r ate
In this menu you set the symbol rate of the desired transponder in kSymb/s.
SYMBOL
8PSK 2/3
A
22000
The symbol rates of the satellite transponders can be found in the current chan-
nel table of the satellite operator, in various satellite magazines and in the
Internet.
• Using button
MULTI
you can toggle the customary standard values
22000/27500 kSymb/s.
• For deviating values use the buttons
</>
to position the cursor under the
digit to be set for the displayed symbol rate.
• Press the
+/–
buttons to enter the corresponding digit of the desired symbol
rate.
• Repeat the procedure by the quantity of the digits to be set.
—> If an input signal is present, its DVB mode (e.g. 8PSK) and the FEC
factor (e.g. 2/3) is displayed.
• Press the
MODE
button.
—> The "Input frequency" sub menu – "
FREQ
" is activated.
i
nPut
frequenCy
In this menu you set the input frequency of the desired transponder in MHz.
FREQ
CN 9
A
11244 +1.8
Once the RF receiver has synchronised to the input signal, any offset to the
target frequency is displayed in MHz, e.g. "
– 1.8
".
If a question mark "
?
" appears in the second line of the display, there is no
input signal present. In this case check the configuration of the antenna system
as well as the preceding settings of the device
• Use
</>
to position the cursor under the digit of the frequency displayed to
be set.