- 21 -
PSU 8-16 I
7.4 m
ains
ConneCtion
• Mount the power cord + strain relief (Fig. 16a) optionally at the rear/bot-
tom side
$
(Abb. 16b). Connect the power cord to the PSU
@
(Abb. 15).
Fig. 16a
Use only the power cord supplied. It is part of the approval and must only be
replaced by an original spare part.
To maintain compliance with current EMC regulations, it is necessary to route
the power cord through the supplied ferrite sleeve
≤
.
Mount the ferrite sleeve as near as possible to the housing of the head-end
station (fig. 16b).
%
$
%
$
≤
Fig. 16b
• Open the ferrite sleeve.
• Make a loop in the power cord and lay the loop inside the ferrite sleeve as
shown in fig. 17.
• Close the ferrite sleeve (fig. 18).
• Connect the power cord of the head-end station to the mains socket.
The head-end station is only completely separated from the mains voltage
by pulling the power supply plug.
Fig. 17
Fig. 18
