GSM Burglar, Manual

Page: 16 / 18

- 15 -
80+
【
00-99
】
+ "Panel
with SMS message"+
【
#
】
Used to customize the SMS message for zone 00-99.
Example: Send message “12348001 Front Door Alarm#” to the alarm
panel will set alarm panel to send SMS message “Front Door Alarm” upon
zone 01 alarm being triggered.
Note: Maximum length of message is 25 characters.
Query the customized
SMS message content Query zone 00-99 the content of SMS message customized.
Example: Send 12348101# to the alarm panel to query for zone 01
message content.
81+
【
00-99
】
+
【
#
】
Note: "1234" string shown above table all represents the password. User can change password and thus
should adjust the commands listed accordingly.
Remark:
This machine can be used as a mobile for conversation. To do that, on the keyboard, put in
#0013812345678# where 13812345678 is the phone number you’re going to connect. At the end of
your call, press DISARM key, press *, then press # to exit.
5.1 After receiving the Panel Alert:
After Panel alerts, it will automatically dial the preset phone number for three times until connected.
When the user picks up the phone, a piece of pre-recorded voice message will be played back
immediately and let the receiver noted about the event. Upon receiving the call, it can also control the
alarm panel remotely via the phone (according to the command below). User will not be asked for
password upon connected and alarm will automatically hang up call within receiving any instruction
within 20 seconds.
[1] key: arming
[2] key: disarming
[3] key: monitoring open [4] key: monitoring closed
[5] key: turn on announcement [6] key: turn off announcement
[7] key: siren ringing [8] key: stop siren sound
[9] key: turn on relay [0] key: turn off relay
[*] key: hang up, system will not dial the next number on list.
Remark:
If not hang up using [*] key or disarm using [2] key, the system will retry to call the next phone numbers
on list until one connected.
Panel will not ask for password when dialing out upon alarming.
5.2 Remote Dialing In Operation:
Remote-control operations can be done via any phone. You can just dial into the alarm panel and user will
be asked for password upon connected and alarm will automatically hang up call within receiving any
instruction within 20 seconds or password is incorrect. (original password 1234)
[1] key: arming
[2] key: disarming
[3] key: monitoring open [4] key: monitoring closed
[5] key: turn on announcement [6] key: turn off announcement
[7] key: siren ringing [8] key: stop siren sound
[9] key: turn on relay [0] key: turn off relay
[*] key: hang up,
[#] key: Enter the system remote configuration mode, Without receiving no instruction, the panel will
automatically hang up after 20 seconds.