GSi VersaLoop, Owner'S Manual, Page: 24 / 52

Chapter 4: Assembly
Chain and Paddles – Installation
Before You Begin
The chain is shipped in 10 ft. lengths and needs to be spliced as required. The direction of the chain is
dependent upon the setup of the VersaLoop™.
NOTE: Make sure to bend the ends of the cotter pins as shown to prevent them from working loose and
causing the chain to break.
1. Remove the end covers (A) from the drive end.
Figure 4-7 Removing the end covers
A End Covers
2. Insert the chain and paddle through the bottom tube from the drive end to the non-drive end.
NOTE: Make sure that the chain is oriented in the desired direction of grain flow.
3. At the non-drive end, route the chain and paddles around the sprocket using an electrical fish tape or
wire to pull the chain through the tube assembly.
24 Pneg-1966 VersaLoop™