GSi VersaLoop, Owner'S Manual, Page: 21 / 52

Chapter 4: Assembly
Gearbox and Motor – Installation
Before You Begin
NOTE: If opposite drive side is required, refer VersaLoop™ – Gearbox Mounting Process, page 36 .
1. Locate the drive end (E) and position it on the ground or stand.
2. Locate the appropriate sized electric motor (A) with gear box (B).
NOTE: Motor specification will vary depending on the VersaLoop™ angle of operation.
3. Locate the shaft side in the drive end.
4. Slide the gearbox (B) onto the shaft.
5. Align the mounting plate (D) holes to the holes in the gearbox flange and secure them with bolts.
IMPORTANT: Make sure to install the shaft protective covers (F) inside the mounting bracket when
installing the bolts and the nuts. Bend the covers at the top and the bottom to the
inside of the mounting bracket to shield the shaft.
6. Align the gearbox (B) and shaft keyways and insert the drive key.
7. Attach a key stop to the end of the shaft using a 1/2 bolt.
8. Attach the shaft dust cover to the end of the gear box.
9. Mount the motor (A) to the gear box (B) and ensure to align the key shaft (C) and coupler.
NOTE: Make sure to mount the motor (A) to the gearbox (B) with the lifting lug facing up.
Figure 4-4 Gearbox and motor assembly
A
Motor
D
Mounting plate
B Gearbox E Drive end
C
Key shaft
F
Shaft cover
Pneg-1966 VersaLoop™ 21