GSi VersaLoop, Owner'S Manual, Page: 23 / 52

Chapter 4: Assembly
Drive End – Installation
1. Locate the drive end (A) and position it on the ground or stand.
2. Position the connecting band (B) either on the tubes in the drive end (A) or the assembled tube sec-
tion (C) (upper and lower tubes).
3. Join the open end of the tube section (C) (upper and lower tubes) to the tube sections in the drive
end (A).
4. Center the connecting band (B) over the tube section connections.
5. Position the joint of the connecting band (B) so that the overhanging lip will shed water and not direct
it to the tube.
6. Install the bolts (D) and nuts (E) per each connecting band (B).
Figure 4-6 Installing the drive end
A
Drive end
D 3/8 x 1 1/2 in. bolt
B
Connecting band
E
3/8 nut
C Tube section
Pneg-1966 VersaLoop™ 23