GSi PNEG-222, Installation Manual, Page: 15 / 48

4. Recommended Method for Full Floor Installation
PNEG-222 48' Diameter Bin Cor-Lok and Cut-Lok Flooring 15
IMPORTANT: First piece of flooring must start at the proper distance from centerline of bin. Refer to floor
layout on Page 24 . First piece may need to be trimmed for length to fit at the proper location.
(See Figure 4C.)
Figure 4C
4. Install flooring starting at the bin wall on the opposite side of the unload auger. Floor planks should be
placed perpendicular to the unload auger with the outside edge the correct distance from the center
of the bin.
(See Figure 9A on Page 24.) Be sure the flat edge of the floor plank is facing the bin wall
and the open channel edge (E) is facing towards the center of the bin. (See Figure 4C.) Position the
supports for the first/shortest floor plank according to the number of bin rings and corrugation as
shown in the illustrations
on Pages 27-37 or stated in the charts on Pages 38-39 . Attach the flashing
to flooring and bin wall to hold plank in place. ( See Page 21 for flashing installation.)
Ref # Description Ref # Description
E Open Channel Edge I Inside Hook
F Flat Edge J Straight Tab
G Bin Wall K Outside Hook
H Correct Assembly Method L The Grandstand
Attach flashing to ends of first plank here, just to
hold it in place.
NOTE: These two (2) pieces of
flashing will need to be removed and repositioned
when installing the rest of the flashing.