GSi Cumberland PNEG-1333, Installation And Owner'S Manual

Page: 36 / 68

4. Assembly
36 PNEG-1333 Turkey Poult Feeder System
Winching
Building Safety
Choose Correct Winching System
Cumberland strongly recommends the use of the correct winching system for the feed line. The winch
must have the capacity to lift the weight of the feed line. If in doubt, please contact Cumberland or
your dealer.
Winching systems should be rated to lift the weight load to be raised and lowered and must bear the
CE mark and comply with all the requirements of EC Machinery Directive, Directive 89/392/EEC.
Use of non-genuine parts may result in accident, injury or failure of the system.
All winching systems should be fitted with a check chain so that when the feed line is in the raised position,
it cannot fall, even if the winch cable snaps or the winch fails.
For proper installation, the feed line must hang straight and reasonably level. Winch systems should be
carefully planned to keep all cables clear of building components, trusses, electrical wiring and gas and
water lines. Drops to the feeders should be straight so as not to impose improper loads on the feeder
when raised.
Safety when Raising and Lowering
The main risk when raising and lowering the feed line is that a cable may snap or slip. This may result in
cable whip or the feed line falling. Therefore, the use of a hard hat and face shield is recommended.
The winch should be placed in the building so that it is not too close (3' minimum) to any section the
feed line in case of the feed line falling.
Take extreme care when raising and lowering the Pan Feeder. Cables used for winching are
under tension.
• Always check that the cables and clamps are in good condition. Replace any frayed or
damaged cables and clamps.
• Never raise or lower the feed line with another person in the building unless they are clear of
the system and cables.
• Once the feed line has reached the fully raised position, lock the check chains.
1. After deciding where the feed line is to be installed, mark a straight line on the ceiling or rafters the
full length of the feed line. Center the line directly over where the feed line is to be installed.
Before attempting to install a winching system, it is important to verify the
structure of the poultry house can carry the added weight of the pan feeding system.
See Capacities and Specifications Section on Page 12 to assess the weight to be
carried. Seek the advice from a structural engineer.
WARNING