8. Attach the flashing to flooring and sidewall (9) to hold floor plank (4) in place. Refer to the
for flashing installation.
9. Attach two flashings to the both ends (33) of first floor plank here, just to hold it in place.
NOTE:
These two flashings will need to be removed and repositioned when installing the rest of the
flashing.
10.
POSITION THE NEXT ROW OF SUPPORTS ACCORDING TO THE CHALK LINES (6)
and
support layout. The straight tab (12) should “snap” under the first (previous) floor piece.
11.After the supports in the row are correctly positioned, install the next floor piece by hooking the
open channel edge (7) under the outside hooks (11) of the floor supports.
12.Push down sharply on the edge of the floor piece until it snaps into the previous floor piece.
Continue this process for the rest of the floor cutting planks for the center and intermediate wells as
needed.
13.Refer to the
for center well support locations.
NOTE:
• Whenever there is more than dimension “B” divided by three inches (B/3") of plank (4)
unsupported beside the sidewall (9), there should be a support on that plank (4) or a
support on each of the planks (4) adjacent to it such that no more than dimension “B”
divided by three inches (B/3") is unsupported.
• For example: 2.66" bin with 8 rings has a “B” dimension of 22". Take 22"/3" = 7.33"
(Round to 7"). Therefore, there should be no more than 7" of unsupported floor
plank (4).
14.Some floor planks (4) will need to be spliced together. Refer to the
,
and
Plank Lengths
for more information.
15.Install plank length “A” first, then install the corresponding plank length “B” by butting plank “B” up
against plank “A”.
16.Make sure that the planks are supported by a grandstand on each side of the splice. Continue this
until the floor is complete.
Figure 2-4
Oversplice bolt pattern for small grain floors
4
Floor plank
27
Splice seam
25
Floor oversplice (CLF-1763SG)
28
Dashed lines indicate items under the oversplice.
26
Self-drilling screw (S-280)
16
PNEG-223
60' Cor-Lok and Cut-Lok Flooring
Summary of Contents for 60' DIAMETER
