GSI Group X Series Sweep, Operator'S Manual

Page: 38 / 80

7. Maintenance
38 PNEG-1858 12" and 16" “X” Series Sweep
M. Type of Lubrication
The type of lubrication required, for each component, is listed. (See Chart Below) .
Lubrication - Casters and Misc. Equipment
NOTE: The pour point of the lubricant selected should be at least 10°F lower than the expected minimum
ambient starting temperature. Extreme pressure (EP) lubricants are not recommended for average
operating conditions.
Type of Lubricant
Equipment Lubrication Specification
Nylon Flight Bearings None Required None Required
Casters Shell Oil Company Alvania #2 (or equivalent)
Too much oil will cause overheating and too little will result in gear failure. Check
oil level regularly.
NOTICE
Extreme pressure (EP) lubricants are not recommended for average operating
conditions. Failure to observe these precautions could result in damage to or
destruction of the equipment.
NOTICE
Under Extreme operating conditions, such as rapid rise and fall of temperatures,
dust, dirt, chemical particles, chemical fumes or oil sump temperature above
200°F, the oil should be changed every one to three months, depending on
severity of conditions.
NOTICE
CAUTION
If the unit is used in the food or drug industry (including animal food) consult the
petroleum supplier for recommendations on lubricants which meet the
specifications of the FDA, USDA and/or other authoritative bodies having
jurisdiction. Standard lubricants are not suitable for these applications or
these industries.
WARNING
Oil, housings and other components can reach high temperatures during
operation and can cause severe burns. Use extreme care when removing
lubrication plugs and vents while servicing the unit.