GSI Group X Series Sweep, Operator'S Manual

Page: 16 / 80

3. Product Overview
16 PNEG-1858 12" and 16" “X” Series Sweep
Product Information
1. The “X” Series Sweep includes the following components:
Control Panel
Two (2) Motors
Motor Covers
Motor Mount
Auger Flighting
Auger Back Shield Assembly
Caster Wheels
Track
Shield Brush
2. The following components are NOT included with the “X” Series Sweep:
Track Anchors
Electrical Components
- Wire
- Fittings
- Conduit
3. The unit will operate only in a round grain bin equipped with a center sump in the bin floor.
General Information
1. GSI reserves the right to improve its product whenever possible and practical to do so. We reserve
the right to change, improve and modify products at any time without obligation to make changes,
improvements and modifications on equipment sold previously.
2. This new bin sweep auger has been engineered and manufactured to give years of dependable
service. The care and maintenance of this equipment will affect the satisfaction and service obtained.
By following the instructions and recommendations, the owner should receive quality service for
many years. If additional information or assistance is required, please contact GSI.
This “X” Series Sweep is a single pass sweep. Consult the manufacturer of the
storage tank regarding the requirements or restrictions of the sweeping process.
The manufacturer may require a multiple pass sweep.
CAUTION
WARNING
NEVER enter a grain bin unless ALL power driven equipment has been shut down.
Disconnect and lock out power before entering the bin or servicing the equipment.