Gsertel 901622, User Manual

Page: 26 / 78

Hexylon High-performance portable meter
26
slots) When a slot is enabled (for example
slot 3, freq. 1210MHz), the meter will tune
into the slot frequency (1210MHz) and
will set the slot with the meter parameters:
frequency, band (powering), and DiSEqC.
In addition, a SCR icon will be shown in the
bar at the top (SCR3) to indicate that the
slot is enabled. While the slot is enabled,
all the setting changes of the meter, will
be applied to the currently slot (SCR3).
• Aim antenna:
Emits an audible signal . This is a useful
feature to point antennas without having
to look at the display
5. LTE check
The presence of signals in 4G and 5G bands in
distribution systems DTT, can affect the quality of
the TV signal.
This function makes an analysis of the 4G and
5G signals and its influence on digital terrestrial
television signal (UHF band), and it also estimates
the need to insert a filter at the input of a Digital
Terrestrial Television (DTT) system, in order to
minimize interferences that may cause the signal
on the DTT signal.
When you select this function, only the 4G
Downlink and the 4G Uplink bands are analysed.
You must display the Options Context Menu to
analyse the 5G band.
4.2.- Options context menu
• Powering:
- VDC: Selects the preamplifier powering.
- DiSEqC (only satellite band): selects the
DiSEqC parameter (Sat A, Sat B, Sat C, Sat
D)
- Positioner (only satellite band): makes it
possible to control the DiSEqC motors
used to move mobile parabolic antennas.
This function is available in satellite mode
and when the equipment is powering the
LNB.
Halt: This command stops the motor
movement.
East: Allows to move the motor in the
EAST direction. Each click corresponds to
one step in the movement of the motor
(pitch motors). By holding the key down,
successive movement sequences will be
executed until the key is released.
West: Motor movement in the WEST
direction. Each click corresponds to
one step in the movement of the motor
(pitch motors). By holding the key down,
successive movement sequences will be
executed until the key is released.
Store: 8 storage positions are available
to store at up to 8 antenna positions . This
command allows one of 8 positions to be
chosen where the current position of the
antenna will be stored.
Goto: recovers one of the 8 positions
for the antenna that has been previously
stored
- SCR (only satellite band): Selects the SCR
parameters (multiswitch, standard and