User Manual 9065/9065plus
MAN10772-00 113
Options
The Controller Board (only for 9065)
The 9065 printer’s interface available configurations are:
Controller board with serial, parallel and USB interfaces
Controller board with LAN and parallel interfaces.
The original configuration may be modified by ordering the controller board with the desired interfaces and
replacing the existing board with it.
Installing the Controller Board
Follow the reported instruction in case of Controller Board replacement.
Handling the Controller Board
Attention:
Do not remove the Controller Board from the protective package until instructed to
do so. Static electricity, though harmless to you, can damage sensitive Controller Board components. Use
the information in this section to avoid damaging a Controller Board.
Limit your movement. Your movement can create static electricity that, when released to the Controller
Board, can damage the electronic components on the Controller Board. Sliding your foot across carpeting
is an example of how you create unwanted static electricity.
Handle the Controller Board only by the edges and prevent others from making direct contact with it.
Before removing the Controller Board from the protective package, ground the package to exposed metal
at the back of the printer. This will release any static charge that may have developed on the package or on
your body. Hold the package against the metal for at least two seconds.
When you are instructed, remove the Controller Board and install it directly into the Controller Board slot
without setting it down. If you have removed the Controller Board from the protective package and cannot
immediately insert it in the printer, place the protective package on a flat surface, and set the Controller
Board on top of the protective package.
Replacing the Controller Board
Attention:
Ensure that the printer is powered off before installing or removing the Controller Board.
If the Controller Board is installed while the printer is powered on, the controller will not synchronize with the
printer mechanism board.
Unpredictable printer behavior will result.
Perform the following steps to replace the Controller Board:
1. Ensure that the printer is powered off. Installing the Controller Board with the printer power on will result
in unpredictable printer behavior.
2. Use the screwdriver that came in the Controller Board box to remove the existing
Controller Board and pull out the card.
