13
EN
•
Tighten all hose nuts by hand.
Never use a tool when tightening
the nuts.
•
Open the taps completely after
making the hose connection
to check for water leaks at the
connection points. If any leaks
occur, turn off the tap and
remove the nut. Retighten the nut
carefully after checking the seal.
To prevent water leakages and
damages caused by them, keep
the taps closed when the machine
is not in use.
Connecting to the drain
•
The end of the drain hose must
be directly connected to the
wastewater drain or to the
washbasin.
A
WARNING:
Your house
will be flooded if the hose
comes out of its housing
during water discharge.
Moreover, there is risk
of scalding due to high
washing temperatures! To
prevent such situations and
to ensure smooth water
intake and discharge of the
machine, fix the end of the
discharge hose tightly so
that it cannot come out.
•
The hose should be attached to a
height of at least 40 cm, and 100
cm at most.
•
In case the hose is elevated
after laying it on the floor level
or close to the ground (less than
40 cm above the ground), water
discharge becomes more difficult
and the laundry may come out
excessively wet. Therefore, follow
the heights described in the
figure.
40 cm
100 cm
•
To prevent flowing of dirty water
back into the machine and to
allow for easy discharge, do not
immerse the hose end into the
dirty water or do not drive it in the
drain more than 15 cm. If it is too
long, cut it short.
•
The end of the hose should not
be bent, it should not be stepped
on and the hose must not be
pinched between the drain and
the machine.
•
If the length of the hose is too
short, use it by adding an original
extension hose. Length of the
hose may not be longer than 3.2
m. To avoid water leak failures,
the connection between the
extension hose and the drain
hose of the product must be fitted
well with an appropriate clamp as
not to come off and leak.
