- 4 -
SMCIP 402 C/T
1
s
afety
regulations
and
notes
• This device is subject to the provisions of protection class II .
• Do not operate the device without equipotential bonding!
• The standards EN/DIN EN 50083 resp. IEC/EN/DIN EN 60728 must be
observed.
• Observe the relevant standards, regulations and guidelines on the installa-
tion and operation of antenna systems.
• Observe the relevant VDE regulations.
• Do not perform installation and service work during thunderstorms.
• Assembly, installation and servicing should be carried out by authorised
electricians.
• Switch off the operating voltage of the system before beginning with assem-
bly or service work or pull out the mains plug.
• Install the system so it will not be able to vibrate…
- in a dust-free, dry environment
- in such a manner that it is protected from moisture, fumes, splashing wa-
ter and dampness
- somewhere protected from direct sunlight
- not within the immediate vicinity of heat sources
- in an ambient temperature of 0 °C to +40 °C. In case of the formation of
condensation wait until the system is completely dried.
• Ensure that the device is adequately ventilated.
Do not cover the ventilation slots.
• Do not install the device in cabinets or recesses which are not ventilated.
• Do not place any vessels containing liquids on the device.
• Do not place anything on the device which could initiate fires (e.g. candles).
• Due to the risk of fires caused by lightning strikes, we recommend that all
mechanical parts (e.g. distributor, equipotential bonding rail, etc.) be mounted
on a non-combustible base. Wood panelling, wooden beams, plastic covered
panels and plastic panels are all examples of combustible bases.
• Avoid short circuits
• No liability is accepted for any damage caused by faulty connections or
inappropriate handling.
•
Test the firmware versions of the device and update them if necessary. The
current firmware versions can be found at "www.mygss.eu".
Take action to prevent static discharge when working at the device!
