8
DISHWASHER / USER'S MANUAL
/44 EN
3
INSTALLATION
To make the product ready for use, make
sure that the electricity, tap water supply and
water drainage systems are appropriate
before calling the Authorised Service Agent.
If they are not, call a qualified technician
and plumber to have any necessary
arrangements carried out.
C
Preparation of the location and
electrical, tap water and waste
water installations at the place
of installation is under customer's
responsibility.
B
Manufacturer shall not be held
responsible for damages arising
from processes carried out by
unauthorised persons.
A
Prior to installation, visually
check if the product has any
defects on it. If so, do not have
it installed. Damaged products
cause risks for your safety.
C
Preparation of the location and
electrical, tap water and waste
water installations at the place
of installation is under customer's
responsibility.
C
Make sure that the water inlet
and discharge hoses are not
folded, pinched or crushed
while pushing the product into
its place after installation or
cleaning procedures.
When placing the product, pay attention not
to damage the floor, walls, piping, etc. Do
not hold the product from its door or panel
to move it.
Appropriate installation
location
•
Place the product on a solid and flat
floor that has sufficient load carrying
capacity! The product must be installed
on a flat surface in order for the door to
be closed comfortably and securely.
•
Do not install the product at places
where temperature may fall below 0ºC.
•
Place the product at least 1 cm away
from the edges of other furniture.
•
Place the product on a rigid floor. Do
not place it on a long pile rug or similar
surfaces.
B
Ensure the power cable does not
get trapped under the product.
•
Make sure that you select a location that
will allow you to load and unload the
dishes in a fast and comfortable manner.
•
Install the product in a place close to the
tap and the drain. Select the installation
location by considering that it will not
be changed after the connections are
made.
Connecting water supply
•
Do not use old or used water inlet hose
on the new product. Use the new water
inlet hose supplied with the product.
•
Connect the water inlet hose directly
to the water tap. Pressure coming from
the tap should be minimum 0.3 and
maximum 10 bars. If the water pressure
exceeds 10 bars, a pressure relief valve
should be installed in between.
•
Open the taps completely after making
the connections to check for water leaks.
A
For your safety, close the water
inlet tap completely after the
washing programme is over.
Connection to the drain
Water discharge hose can directly be
connected to the drain hole or sink’s
drainage. The length of this connection must
be min. 50 cm and max. 100 cm from the
Summary of Contents for GNF 41810 W
Page 44: ...FOR A GOOD REASON ...
