- 11 -
Remote Control Battery Installation
The remote control requires two AAA batteries. Below are steps to assist you with
replacing the batteries.
1.
Open the back cover of the battery compartment.
2.
Install the batteries into the battery tray. There is +/- polarity marking in the
battery compartment. Please ensure the polarity is correct.
3.
Close the battery cover.
Caution:
1.
Keep the batteries out of the reach of children.
2.
Don’t attempt to recharge, short-circuit, disassemble, heat up or throw batteries
into a fire.
3.
Always replace both batteries at the same time. Never mix new and old batteries
or batteries of a different type.
4.
If you don’t intend to use the remote control for an extended period, remove the
batteries to prevent possible leakage and corrosion.
Notes:
Do not drop, shake or step on the remote control.
Do not spill water on the remote control.
Aim the remote control directly at the remote sensor, for best use.
If the TV does not operate when operating the remote control from a close
range, you need to replace the batteries.
Installation and Connection
1.
Connect the TV RF source (your external aerial - antenna /satellite TV/CATV net)
to the RF IN port as shown below. You can use 75Ω coaxial cable to connect an
outdoor antenna.
