Grundig GIN 090, Installation Manual

Page: 34 / 168

34 / 56 EN
Split-type room air conditioner / Installation Manual
Minimum cross-sectional area of power and signal cables
North America
Appliance Amps (A) AWG
10 18
13 16
18 14
25 12
30 10
Other regions
Rated current of appliance (A) Nominal cross- sectional area
(mm²)
> 3 and ≤ 6 0.75
> 6 and ≤ 10 1
> 10 and ≤ 16 1.5
> 16 and ≤ 25 2.5
> 25 and ≤ 32 4
> 32 and ≤ 40 6
a. Using wire strippers, strip the rubber jacket from both ends of cable to reveal about 40mm
(1.57in) of the wires inside.
b. Strip the insulation from the ends of the wires.
c. Using a wire crimper, crimp u-lugs on the ends of the wires.
Pay attention to live wire
While crimping wires, make sure you clearly distinguish the Live (“L”) Wire from other wires.
A Warning
All wiring must performed strictly in accordance with the wiring dirgram located inside
the outdoor unit s wire cover.
2. Unscrew the electrical wiring cover and remove it.
3. Unscrew the cable clamp below the terminal block and place it to the side.
4. Match the wire colors/labels with the labels on the terminal block, and firmly screw the u-lug of each
wire to its corresponding terminal.
5. After checking to make sure every connection is secure, loop the wires around to prevent rain water
from flowing into the terminal.
6 Outdoor unit installation