Do not install the unit in humid, dusty or sooty locations. Doing so may cause fire or electric shock. Install it in a
place with good ventilation.
When installing the unit, fasten it securely and firmly. A falling unit may cause personal injury.
If you want to relocate the already installed product, be sure to turn off the power and then move or reinstall it.
If the PTZ system looses its power supply during freezing temperatures and the power supply returns
afterwards, the Swiftdome Camera will first heat up internally to +3° C and then the initialiasition will start. In
this way it can be prevented that the sliding contacts and the motors get damaged through a cold start.
General Operation Requirements:
At least one control device is required for operation, such as a Control Keyboard, a DVR or a PC. The Swiftdome
Cameras contain a built-in receiver that decodes commands originating from a control device.
Connect the Dome Cameras to other devices, as shown in the diagram, to complete a video surveillance system.
NOTE: To extend the network distance up to 1.2 km (4000 feet) and to protect the connected devices, it is highly
recommended to place a repeater at the mid-point. However, a repeater may be also needed in a network
distance of less than 1.2 km if the used cables are not the CAT 5 / 24 AWG cables (please see section 4.6.4 RS-
485 Connector Definition). Please refer to the repeater’s manual for detailed information.
4.1. Preparation for Dome Camera Setup
4.1.1. Setup Preparation for GCA-C0245P
The following installation procedure is for the Camera model GCA-C0245P. This camera is supplied with a
sunshield housing. Please follow the steps below to complete the housing installation for the Dome Camera.
STEP 1
Unpack the Dome Camera’s package and take out the Dome
Camera unit.
3
English
Summary of Contents for GCA-C0245P
Page 2: ......
Page 16: ...14 English...
