18
DISHWASHER / USER INSTRUCTIONS
/41 EN
Preparation
Please check the rinse aid indicator on the
display to see whether there is adequate
amount of rinse aid in the dishwasher or
not. You need to refill the rinse aid reservoir
with rinse aid whenever rinse aid warning
indicator appears on the display of your
machine.
1. Open the lid of the rinse aid reservoir by
pulling the latch in the direction of the
arrow (B).
2. Fill the reservoir until “MAX” level.
3. Turn the rinse aid amount adjuster
manually to a position between 1 and
6 (C). If there are stains on tableware
items after washing, level must be
increased and if there is a blue trace
after wiping them by hand, it must be
decreased. This is set to position 4 as
factory default.
4. Close the lid of the reservoir by pressing
on it lightly.
Above this limit regeneration salt and rinse
aid must be added. Refer to the instructions
on the packaging of the combined detergent
whether it is suitable for the hardness level of
the water supply.
C
While using combined tablet
detergents, contact with the
detergent producers if your
dishes are wet and/or if
you notice limescale spots
particularly on your glasses after
the washing programme is over.
When you switch to powder, liquid/
gel or tablet detergent from a
combined tablet detergent:
1. Make sure that salt and rinse aid
reservoirs are full.
2. Set the water hardness to the highest
level and perform an empty run.
3. After the empty washing cycle, review
the user manual and readjust the water
hardness level so as to suit the water
supply.
4. Make the appropriate rinse aid settings.
C
Depending on the model, salt
indicator and/or rinse aid
indicator should be enabled
again if they are disabled
before.
Rinse aid
C
The rinse aid used in dishwashers
is a special combination
that aims to increase drying
efficiency and prevent water
or lime stains on the washed
items. For this reason, care must
be paid to have rinse aid in the
rinse aid reservoir and to use
rinse aids produced specially for
dishwashers only.
