Grundig 40 VLE 8160 SL, Manual

Page: 69 / 83

­69
ENGLISH
Settings­for­motorised­antennas­
(DiSEqC­1.2)
Your television set supports motorised satellite
systems in compliance with DiSEqC 1.2. This
function allows the satellite antenna to be oper-
ated via the television set.
1 Open the menu with » i «.
2
Select the line »SOURCE SETUP« with »
V
«
or »
Λ
« and press »
●
« to confirm.
– The »SOURCE SETUP« menu appears.
3
Select the line »DiSEqC 1.2« with »
V
«
or »
Λ
«. Select the option »On« with »
<
«
or »
>
«
– The line »User Mode« is active.
Note:
7
Additional operations are explained in the
following sections.
SPECIAL­SETTINGS
­----------------------------------------------------------------------------------------------------------
User­mode
You can adjust the alignment of the satellite an-
tenna to each individual satellite. These settings
will be saved so that the antenna can later be
easily guided to each saved alignment.
1 Select the line »User mode« with »
V
«
or »
Λ
« and press »
●
« to confirm.
– The »USER MODE« menu appears.
2 Select the preferred option with »
V
«
or »
Λ
«.
– »Satellite«: »Press
●
«, select a satellite with
»
<
«, »
>
«, »
V
« or »
Λ
« and press »
●
« to
confirm.
– »Transponder«: »Press
●
«, select the tran-
sponder from which the signal is being
received with »
<
«, »
>
«, »
V
« or »
Λ
« and
press »
●
« to confirm.
– »Moving Mode«: Use »
<
« or »
>
« to select
the option »Discrete« or »Continuous«.
– »Discrete«: Moves the antenna in
defined steps to the west and the east.
– »Continuous«: Moves the antenna to the
west or east continuously.
– »Step Size«: Use »
<
« or »
>
« to select the
number of steps with which the antenna
should turn. »Step Size« is only active
when the »Transport Mode« was set to
»Discrete«.
– »Move Motor«: Aligns the antenna with
the selected satellite. Use »
<
« to align it to
»West«, use »
>
« to align it to »East«.
– »Go To Stored Position«: Aligns the antenna
to a saved satellite position. Up to 50 po-
sitions can be saved. »Press
●
« and then
select the saved position with »
<
« or »
>
«.
Press » « (green) to confirm – the anten-
na will be aligned with the saved position.
– »Store Stored Position«: The current anten-
na alignment is saved.
3 Press »
i
« to end the setting.