Grundig 40 VLE 8160 SL, Manual

Page: 77 / 83

­77
ENGLISH
INFORMATION
­---------------------------------------------------------------------------------------------------------------------
Displaying­signal­information
(for digital channels only)
1
Open the menu with »
i
«.
2 Select the line »SOURCE SETUP« with »
V
«
or »
Λ
« and press »
●
« to confirm.
3 Select the line »Signal Information« with
»
V
« or »
Λ
« and press »
●
« to confirm.
– Information on the channel, network,
modulation, symbol rate, quality and
signal strength is displayed.
Notes:
7
The signal information changes in ac cord-
ance with the current input source.
7
The signal properties are displayed in the
lower section of the menu. The further the
bars for »Quality« and »Signal Strenght«
extend to the right, the better the reception
signal.
7
The signal level not only depends on your
receiver system, but also on the channel
which is currently active. Remember this
when aligning your antenna based upon
the signal level display.
4 Press »
i
« to close the menu.
Pre-programming­the­remote­
control­for­other­GRUNDIG­
devices
7
»DVB« has been pre-programmed for op er-
ating a GRUNDIG digital receiver (remote
control level 1).
7
»DVD« has been pre-programmed for oper-
ating a GRUNDIG DVD player.
7
»AMP« has been pre-programmed for oper-
ating a GRUNDIG AV receiver.
7
The functions available depend on the
model of the device you are using. Just try
it out.
Changing­the­pre-programming­­
of­the­remote­control
1
Press and hold »
M
« and simultaneously
enter the three numbers of the corre sponding
code:
– » 1 «, » 2 «, » 3 « for a GRUNDIG DVD player.
– » 4 «, » 5 «, » 6 « for a GRUNDIG DVD record-
er.
– »
1
«, »
4
«, »
7
« for a GRUNDIG digital
receiver (remote control level 1).
– »
2
«, »
5
«, »
8
« for a GRUNDIG digital
receiver (remote control level 2).
– »
3
«, »
6
«, »
9
« for a GRUNDIG digital
receiver with a hard disk (PDR).