K-Series
I/O Manual
Prepared by.
Rev. No.
0
Date.
11-Jan-11
Page.
19 / 25
6.3.2.2
Leakage Sensor
There are two wires, both black and the
identification marking is SS (Seal Sensor). The
resistance measured with a multimeter should be
over 20 Kilo Ohm.
(
Do not use Mega Tester for this test
).
6.3.2.3 Bearing Temperature Sensor
There are two wires, both red and the identification
marking is BS (Bearing Sensor). The resistance
measured with a Multi-Tester should be between 100
Ohm-120 Ohm. Tested by Multi Tester.
(
Do not use Mega Tester for this test
).
6.4 Control Panel wiring
6.4.1 Wiring of Inlet, Outlet and Motor Protector
6.4.1.1 Direct On Line (D.O.L)
fig. 17
fig. 18
fig. 16
