7
Revision date: 12.16.20
Automated Roll-Up Sides
Attach Motor Adapter to Roll-Up Conduit
Complete these steps:
1. Measure 1-1/8" in from the end of the roll-up conduit and mark the
mounting hole location for the motor adapter.
2. Slide the motor adapter onto the conduit pipe, aligning bolt holes with
drilled hole in conduit.
3. Tigten bolts using a 16mm and/or 17mm socket wrench to secure adapter
to conduit. (Bolt heads may be different sizes.)
4. Continue with the next procedure.
ATTACH MOTOR ADAPTER TO ROLL-UP CONDUIT
ATTENTION:
If the roll-up conduit is not attached to the roll-up side panel,
return to the roll-up panel assembly section of the
main building instructions
and complete the steps to install the side panel and attach the roll-up conduit to
the side panel. Return to this guide and continue with the steps below.
EXTENSION PIPE:
If the roll-up conduit is already installed, a 12" extension
pipe (131S012) is included to add to the roll-up conduit
if needed
. Adding this
12" pipe prevents the need to completely detach the roll-up panel from the
roll-up conduit if additional conduit length is needed to reach the drive motor
and adapter. Use the motor position to better judge how long the roll-up conduit
needs to be. Add the extension pipe if needed and cut to length. Secure the
pipe to the roll-up conduit using a Tek or similar self-tapping screw.
Use of the extension pipe depends on whether the installed roll-up conduit is
long enough to reach the new positon of the drive motor with installed adapter.
Roll-Up Conduit with
Adapter Mounting Hole
Adapter Attached to
Roll-up Conduit
Gather parts:
• 12" Extension Pipe for Roll-Up Conduit (131S012). Use depends on setup;
pipe may not be needed.