4
Automated Roll-Up Sides
Revision date: 12.16.20
Remove Some Manual Roll-Up Panel Components
Complete these steps:
1. With the roll-up panel in the down or closed position, disconnect the roll-
up conduit from the gearbox.
2. Slide the gearbox and roller bearing assembly off the 102570 aluminum
track. Ensure the anti-billow rope is intact and tight to hold the roll-up
panel in place.
NEVER ALLOW PANEL TO REMAIN UNSECURED!
3. At the top of the aluminum track, disconnect the track from the threaded
rod attached to the end rafter or end frame.
4. Set the gearbox and 102570 track aside; these are not needed for the
automated roll-up side.
5. Continue with the procedure on the next page.
ATTENTION:
If the manual roll-up side components (gearbox, roller bearings, aluminum track, etc.) included with the building are not installed, skip this page
and continue with the next page to install the automated roll-up side components included with this kit.
102569
Bearing
103544
Mounting
Plate
102570
Aluminum
Channel
102717
Gearbox Drive
103496
Gear Box
In addition to smaller items not shown, these items (included with the
original
manual roll-up panel
)
are not used
when the automated roll-up side panel
components are installed:
STEP 1
STEP 3
Manual spin handle
is not needed for
automated roll-up side.