Grouser Products 10204424, Manual

Page: 15 / 36

15
7. Connect the cable from the joystick to
the wire harness (5).
8. Drill 1 - 5/16” hole in the fuse compartment and
attach the joystick controller to the compartment
with 1 - 1/4” bolt, 1 - 1/4” washer, and 1 - 1/4” nut
(6).
19.78 Ref.
13.37
4.45
1.20 Ref.
11. Drill 3 - 1-1/16” holes on the right side of the rear
tractor frame to hold the valve mount. Use the diagram
above to locate the first hole and then use the mount as a
guide to mark the other 2 holes (7).
Note: Some tractor parts are not shown for clarity.
12. Attach the valve mount to the tractor with 3 - 1” x 2”
bolts and 3 - 1” nuts.
13.
Install all fittings into the control valve as seen in the
diagram on page 18.
14.
Attach 1 - 41” hose to the 90° fitting in the T
O
port on
the valve (8).
15.
Attach 1 - 52” hose to the 90° fitting in the LS port on
the valve (9).
Note: Valve shown from the bottom.
16. Attach the control valve to the valve mount with
4 - 12mm x 30mm bolts and 4 - 12mm flat washers. See
Page 19 for correct orientation of the valve.
Note: Valve location is dependent on hose lengths
and any aftermarket parts. Use dimensions as a
reference, some adjusting may be necessary.
9. Route the wire harness below the foam and
through the bottom of the fuse compartment.
Follow the lift and pitch hoses to the rear of the
tractor.
10. Secure the wire harness with zip-ties and
protect around sharp corners and moving objects.
Rear
Front
5
6
7
9
8
LS Port
T
O
Port