Groupe Atlantic CORFIRST, Installation, Use And Maintenance Instructions

Page: 18 / 82

U0594061-C Page 18 / 82 CORFIRST / CORSUN 2 / CORFLOW
EN
4. FITTING MAGNESIUM PROTECTION ON THE UPPER BASE
Refer to the specific Anode manual for the installation.
CORFIRST 500L 750L 900L 1000L 1500L 2000L
Dimension of rough anode on upper
base
400 500 800 800 1000 650
Minimum fitting dimension + riser
blocks 2
2250 2385 2965 3210 3165 2730
CORSUN 2 500L 750L 900L 1000L 1500L 2000L
Dimension of rough anode on upper
base
600 500 400 400 650 650
Minimum fitting dimension + riser
blocks 2
2450 2385 2565 2810 2815 2730
CORFLOW 500L 750L 900L 1000L 1500L
Dimension of rough anode on upper
base
500 800 1000 1000 1000
Minimum fitting dimension + riser
blocks 2
2350 2685 3165 3410 3165
5. HYDRAULIC CONNECTION
Before proceeding with the hydraulic connection, the supply pipes must be thoroughly
cleaned to avoid introducing metal or other particles into the tank.
If metal pipes are used, the connection to the hot water outlet must use a dielectric pipe
joint or cast-iron sleeve to prevent galvanic corrosion (iron-copper). Brass connections
are prohibited here. A certified safety unit or non-return flap and safety valve assembly is
obligatory.
If the network supply pressure is ≥ 5 bar, a pressure reducer must be fitted to the distribution
outlet. A pressure of 3 to 4 bar is recommended. Check when hot that the pressure does not
exceed 6 bar. .
Fit a bleed outlet to the tank´s top connection (DHW outlet).
To avoid clogging the installation´s components (heat exchangers, safety valve, safety unit)
with sludge, a filter must be fitted to the domestic cold water supply outlet feeding the tank.
The domestic hot water in the tank can reach a high temperature. It is thus essential to fit a
thermostatic mixing valve before water is distributed to the taps. The temperature setting at
the taps should comply with the regulations in force.
If COMPOSITE MATERIAL pipes (PER, PVC etc.) are used a temperature limiter must
be fitted to the tank output and adjusted according to the performance of the material
used.