www.gronomics.com
East Bethel, MN USA
763-753-7374
Continued
2
Parts Identifi cation Box 2
Remove contents from Box 2 of 2.
Stack matching pieces in piles. Using the parts list,
locate and count the individual pieces and verify that
you have received the correct number of pieces.
NOTE: It is recommended to place a protective layer
between the ground and the pieces during assembly.
Box 2 of 2
ITEM
QTY.
PART #
DESCRIPTION
8
6
TTP2639
Table Top Panels, 2” x 6” x 39-1/2”
9
1
TTCP2639
Table Top Center Panel w/Hole, 2” x 6” x 39-1/2”
9
8
Corner Post Assembly
3
NOTE: Do not fully tighten screws on legs and side braces
during assembly.
NOTE: Once the leg assembly is completed and table is
placed on a level surface fully tighten screws.
Locate one 3-1/4” x 3-1/4” x 42” corner post labeled “X”
(Item 1) and one corner post 3-1/4” x 3-1/4” x 42” labeled
“O” (Item 2). Place the two corner posts on the ground
with the X & O located as shown. The two pre-drilled holes
facing up and two pre-drilled holes facing to the outside (at
the top of the corner posts).
NOTE: The two pre-drilled holes at the top of the corner
posts (facing up) (opposite of the X & O) should be farther
down and closer together than the two pre-drilled holes
located to the outside.
1
2
Pre-drilled Holes
Located to the
Outside
Pre-drilled Holes
Facing Up
Pre-drilled Holes
Located to the
Outside
Bottom of Corner Posts
