www.gronomics.com
East Bethel, MN USA
763-753-7374
Continued
Table Top Center Panel Assembly
Align the center mark of the table top center panel w/hole
(Item 9) with the previous mark on the on the side brace
(Item 3). Move the center panel w/hole in or out until the 9”
mark on the table top center panel w/hole is fl ush with the
outside edge of the side brace.
Align the opposite end of table top center panel w/hole, with
the mark on the other side brace.
NOTE: When both ends of the table top center panel w/hole
are aligned, hold down on the table top center panel w/hole
and install the two
5/16” x 2-1/2” screws (Item 7) into the
pre-drilled holes on each side brace and tighten screws into
the table top center panel w/hole.
NOTE: DO NOT over-tighten screws. Over-tightening the
screws will cause the screws to penetrate through the table
top panels.
Rubber Cap
Stud
10
10
12
12
9
3
Align Marks
7
Table Top Panel Assembly
Place a 2” x 6” x 39-1/2” table top panel (Item 8) (as
shown) and align the ends of the table top panel
with the table top center panel w/hole (Item 9).
Place the table top panel spacer (supplied with kit)
between table top center panel w/hole and the table
top panel. Install screws into the table top panel, at
both ends. (See step 12 for screw installation into
table top panels).
Remove the table top panel spacer and repeat step
13 for the remaining table top panels.
13
13
Panel Spacer
Align Table Top
Panel Ends
9
8
