![background image](http://html.mh-extra.com/html/grone-0/2530-421200/2530-421200_operating-instructions-manual_2269692025.webp)
25
Always replace the whole set of milling cutters. Replacing just one milling cutter is false economy. It will
result in an increased vibration level, extensive tool and other cutters wear and may harm the opera-
tor’s health!
Ensure that the milling cutters are mounted properly after they are replaced and whether they can ro-
tate easily!
Mounting the One-Piece Diamond Cup Wheels
In order to mount a standard cup wheel, you can purchase mounting set.
To mount the diamond wheel cup
1.
Remove the milling head by following the instruc-
tions above
2.
Insert the spacing roller (16) on the spindle in such
a way that the grooves on the roller (17) fi t into the
protrusions on the spindle.
3.
Mount the diamond cup wheel on the roller
4.
Mount and secure the diamond cup wheel using the
back-up ring (18) and the long locking bolt (19) by
tightening it fi rmly.
STARTING OPERATION:
Observe correct mains voltage! The voltage of the power source must agree with the voltage specifi ed
on the nameplate. Equipment marked with 230 V can also be operated with 220 V.
The machine may experience work performance drop if the power tool is connected to portable power
sources (generators) that do not have large enough power reserve.
To switch on the power tool:
1.
Press switch-on interlock button (4)
2.
Pull the on/off trigger (6), while holding the interlock button (4) pressed
MAINTENANCE AND CLEANING:
Before any maintenance work on the rotary hammer itself, pull the mains plug!
All maintenance and repair works that require opening the motor body must be conducted solely by
the central warranty service or an authorized service centre.
Make sure that the power tool, and especially the handles, is dry and clean. They must not be covered
with grease or oil. Keep the ventilation slots clean and not obstructed.
Clean the exterior parts of the body regularly with a slightly damp cloth. Do not use any running water
or any spraying appliances to clean the power tool.
Regularly clean the working parts of the power tool, especially the milling head. Disassemble the power
tool to the level of single milling cutters to make sure it is completely and properly cleaned.
Regularly blow off all interior and exterior components of the power tool with dry compressed air.
19
17
16
18
Frezarka_do_betonu_Full_v05_HR.indd 25
Frezarka_do_betonu_Full_v05_HR.indd 25
2016-10-25 21:46:16
2016-10-25 21:46:16