background image

2

English

Maintenance

Inspect and clean all components and replace if necessary.

Shut off hot and cold water supply. 

Remove battery and separate plug-in connectors,

 

see fold-out page II, Figs [20].

 

I. Cartridge,

 see fold-out page III, Fig. [31].

Assemble in reverse order. When installing the cartridge, 
ensure that the seals are correctly seated. Replace screws 
and tighten alternately.

II. Pull out spray with non-return valve,

 see fold-out page III, 

Fig. [32].

Assemble in reverse order.

III. Battery,

 see fold-out page II, Fig. [20].

The battery must be replaced at the latest 10 years after 
putting the fitting into service.

A required change will be signaled by the indicator lamp of the 
controller and by the faucet. Signaling occurs when using the 
Foot control function

At low battery level, the indicator lamp flashes and the water 
flow starts with three short bursts of water.

In case of an almost discharged battery, the indicator lamp 
flashes and the water flow 

stops

 after three short bursts of 

water.

In case of a discharged battery, the indicator lamp flashes and 
the water will 

not

 flow.

Assemble in reverse order.

Insert battery with correct polarity.

IV. Solenoid valve,

 see fold-out page III, Figs. [33] and [34].

Assemble in reverse order.

V. Control,

 see fold-out page III, Figs. [33] to [35].

Assemble in reverse order.

VI. Check valve and filter, 

see fold-out page III, Fig. [36].

Assemble in reverse order.

Replacement parts

See fold-out page IV (* = special accessories).

Care

Instructions for care of this faucet will be found in the Limited 
Warranty supplement.

Disposal instructions

This category of device does 

not

 belong in the 

domestic waste, but 

must

 be disposed of 

separately in accordance with the relevant national 
regulations.
Dispose of batteries in accordance with national 
regulations.

Fault

Cause

Remedial action

Water not flowing

• Water supply interrupted

- Open shut-off valves/service valves

Water flow does not 
start after unsing the 
Foot control 
function

• Water supply interrupted
• Filter in solenoid valve blocked
• Plug-in connector of solenoid valve without 

contact

• Solenoid valve defective
• No voltage 

- Battery discharged
- Plug-in connector without contact

• Cleaning mode activated
• Sensor system not correctly adjusted to 

ambient conditions

- Open shut-off valves/service valves
- Clean filter
- Attach plug-in connector

- Replace solenoid valve

- Replace battery
- Check plug-in connectors
- Wait 2 minutes
- Increase Foot control parameters 

(5 highest value...1 lowest value)

Water flowing 
continuously 

• Solenoid valve defective
• Sensor system not correctly adjusted to 

ambient conditions

- Replace solenoid valve 
- Reduce Foot control parameters 

(5 highest value...1 lowest value)

Undesired water 
flow

• Sensor system not correctly adjusted to 

ambient conditions

• Activation by moisture
• Potential equalisation not provided

• Fitting not correctly calibrated

- Reduce Foot control parameters 

(5 highest value...1 lowest value)

- Do not place damp cloths on the fitting
- Provide potential equalisation, see section 

Connecting the faucet

- Remove battery and re-insert it. Check again after 

the indicator lamp goes out

Flow rate too low

• Mousseur dirty 
• Filter in solenoid valve dirty
• Shut-off valves, service valves not fully open

- Clean or replace mousseur
- Clean filter
- Fully open shut-off valves, service valves and 

check supply lines

Summary of Contents for LADYLUX 3 CAFE FOOT CONTROL 30 313













Reviews: