Groeneveld MSFi, Operation & Maintenance Manual

Page: 5 / 20

5
MSFI - F801306
Pumping Elements and Looming
The MultiLine SFi kits are pre - calibrated with MSFI - P - B040, blue, pumping elements (0.04cc output per stroke). The 110/220 VAC
pump ’ s integrally adjustable timer is preset to setting #3 (6min run and 30min delay). The 12/24 VDC pump ’ s externally adjustable timer
is preset to setting #4 (3min run and 27min delay). A selection of pumping elements with varying outputs are available to suit almost
any need:
Overview:
The MultiLine SFi kits are pre - loomed from the pumping element to the bulkhead connections on the pump bracket. The push - fit
connectors provide an easy installation of the lines to the bulkhead connectors. The lubrication line should be Groeneveld - BEKA ø4mm,
semi - rigid, nylon tubing. It is recommended that the tubing is pre - filled with grease to save on the need to prime the system once
installed.
From the pump position establish the most convenient route for the lubrication lines. It may be preferred to group the lines into looms
depending on pump location and quantity and positioning of the grease points. If grouping the lines into looms, allow sufficient length
for connection to the bulkhead outlet connectors and the bearings, making an allowance for movement on the machinery. In conjunc-
tion with the
‘ Installation Record ’ sheet (see page 18), fit the number identification sleeves to the lines at the pump and bearing ends.
The loom should be protected along its length with the conduit/spiral binding/sleeving and/or tape (for part numbers see Accessories on
page 16).
Installation:
Working from the furthest point from the pump, feed the lubrication lines through the machine following existing machine services
where possible. Ensure that the lubrication lines are positioned to fit the bearing fittings. Where a bearing is on a moving part, ensure
that the line is sufficient to allow for full movement. To avoid rubbing or friction with moving parts, grommets or protective sleeving
should be used. Also, depending on the severity of movement, compression fittings may be preferred at the bearing points.
Connecting the lines:
Cut each lubrication line to length ensuring a clean, square cut is achieved and connect to the bearing using push fit or compression
connectors. Ensure tubing is pushed firmly into connector. Test the assembly by pulling firmly on the line after installation.
To connect to bulkhead fittings on the pump bracket follow steps 1 - 3 as shown above. Remove plug from bulkhead and push the line
firmly into the bulkhead. Again, ensure tubing is pushed firmly into connector. Test the assembly by pulling firmly on the line after instal-
lation. Using the
‘ Installation Record ’ sheet (see page 18) connect the lines to the corresponding numbered pumping elements.
Note: All damaged lubrication lines should be replaced using genuine spare parts, failure to do so can cause system malfunctions and
major safety issues.
Output pressure
Maximum output pressure from each
pumping element
1740PSI/120 Bar
Standard pump elements for AXL pumps.
Part No. Output/stroke Color Size
MSF - P - R010 0.010 cc Red
Ø4mm
Push - Lock
MSF - P - G015 0.015 cc Green
MSF - P - Y025 0.025 cc Yellow
MSF - P - B040 0.040 cc Blue
MSF - P - G060 0.060 cc Grey
MSF - P - B100 0.10 cc Black
1
REMOVE
2
POSITION LUBRICATION
3
INSERT LUBRICATION
Making the Looms and Connections