14
OM-CBE-10G
Operation
1. To Light
A. Open gas valve on rear left of unit.
B. Push power switch to ON. The display will show SELECT MODE and PRE-
HEATING.
C. Select the desired operating mode. If STEAM was pushed while PREHEATING
was displayed the TEMPERATURE display will show three blinking dashes
until the temperature rises above 230°F.
1. For STEAM mode press the STEAM button.
a. The STEAM indicator will light. After that the display will show three
steady dashes indicating that the steaming temperature has been
reached (the ready condition).
2. For OVEN mode press the OVEN button.
a. The OVEN indicator lights. Adjust the TEMPERATURE knob (the upper
knob) for the desired cooking temperature; the lower limit is 200°F,
the upper limit is 450°F.
3. For COMBO mode press COMBO button.
a. The COMBO and LO moisture level indicators light. Adjust the
TEMPERATURE knob (the upper knob) for the desired cooking
temperature; the lower limit is 200°F, the upper limit is 450°F. If the
cavity temperature is more than 20°F below the selected temperature
the TEMPERATURE display flashes until the temperature is within
20°F of the selected temperature (this signals the ready condition).
b. Push Moisture Level HI. The two side reservoirs fill and the center
reservoir empties. The TEMPERATURE knob operates the same way
as in COMBO LO except that the upper limit is reduced to 350°F.
c. Select Fan Speed HI or LO by pressing Fan Speed HI or Fan Speed LO.
4. In either OVEN or COMBO mode, pressing the CRISPEase
™
button
increases moisture venting from the cavity and boosts oven heating by
5000 BTU, while also draining reservoirs to eliminate additional moisture
addition.
2. To Re-Light
A. Push power switch to OFF. Wait 5 minutes, then repeat step 1.
3. To Shut-Off
A. Push power switch to OFF.
B. Close gas valve on rear left of unit.
CAUTION
WHEN THE UNIT IS MOVED FROM ITS ORIGINAL
POSITION FOR ANY CLEANING OR SERVICE, THE
HOOKS ON RESTRAINING CABLE ASSEMBLY
MUST BE RECONNECTED AT BOTH ENDS.
DETAILED INSTRUCTONS FOR RE-CONNECTION
TO THE APPLIANCE ARE SHOWN UNDER
“INSTALLATION” SECTION, ITEM 3.
Summary of Contents for (2) CBE-10G
Page 23: ...OM CBE 10G 23 NOTES...
